|
The combination of a air to water heat-pump and
solar storage tank into a compact unit gives you the choice to supply
nearly all of your domestic hot water by *renewable energy.
©
©
Air to water heat pump from Blomberg
* In most of the EU countries (not in Ireland at
this time) you the consumer have the choice of buying electricity
as "green electricity"
for the same price or even cheaper as "normal power"
"Green electricity" produced by
renewable energy ie. wind, water and solar power.
Plenty of wind power in Ireland and more to come.
The
heat-pump system consists of:
 |
Environmentally
friendly free FCKW-cooling fluid |
 |
Special
design compressor, power consumption 580W (L15/45) |
 |
Pre
wired with cable and plug 1,5m |
 |
Big
dimensioned gasification unit |
 |
High
rated condenser |
 |
Pressosat |
 |
Combination
filter |
 |
Dryer
& dehumidifier |
 |
Thermostatic
expansion valve |
|
Good
reasons for the combination
 |
Instant
use for solar energy |
 |
Compact
Solution |
 |
Approx.
15 cent for a bath |
 |
Long
life |
 |
German
technology |
 |
Absolute
maintenance friendly. |
 |
Can be
installed nearly anywhere |
 |
Easy to
install, low installation cost |
 |
Modest increase
in cost compare to standard solar tanks |
 |
Completely
recyclable
|
How does it
work?
The
combination system Heat-pump and Solar-storage tank use the existing heat in the room where the unit is installed
ie. boiler room, garage or basement to heat the domestic hot
water or over the ventilation system of the house whereby the
used warm air is being passed through the heat-pump. 75% of the energy for heating the water
is free and 25% comes from
the electricity supplied to run the heat-pump.
WP 5030 SOLAR
Equipped
with:
 |
Mains
switch for heat-pump and the electric water heater |
 |
Temperature
controller for setting up to 55° C. |
 |
Eco
energy setting to 45° C |
 |
Thermometer
|
|
|
The
integrated solar storage tank consist of:
 |
Special-enamel
tank made from steel plate 37-2 |
 |
Working
pressure 6 bar (tested to 12 bar) |
 |
Volume
300 litres |
 |
Solar-heat exchanger
1,3 m² bottom |
 |
Supplementary
heat- heat exchanger
0,8m² top |
 |
Pre
fitted anode against corrosion |
 |
High
density of 50 mm FCKW-free PUR insulation |
 |
Insulating
cover 10 mm |
 |
Pre
fitted electric heating element
as back up 1500 W |
 |
Wight:
160 kg |
|
Application:
You do not need a solar system or boiler with this tank to get your
domestic hot water, the heat-pump can do it all.
There are 7 models to choose from and depending on model, you can use a
boiler (Oil, Gas or Solid fuel) to heat the water. The same goes without
saying that if you have a solar system can be used with the tank or at a
later stage could add a solar water heating system to it. No
problem.
This 2 in 1 combination is used where warm
water is needed starting with the models WP 5018 E for the
small households with 2 people, holiday homes, small workshops.
The models WP 5030 are used for homes with up to 10 hot water outlets
and cover the need for domestic hot water for up to 7people,
they are also used for commercial applications ie.
hairdressers, b&b, guesthouses, supermarkets, butchers and
hotels with up to 10 rooms.
|